The Challenges to Swim Spa Covers

Swim Spas represent unique difficulties when it pertains to covering them.
We can all concur that the swim spa has to be covered when not in use for all the same reasons a hot tub needs a cover. The obstacle is that because of the length of the swim spa and the height of the sides, removing and changing the cover can be a lot harder.
Getting a brand-new swim spa is an amazing event in life. You’re anticipating the workout you’ll receive from using it. Maybe you’re a little relieved to have actually lastly made a selection from the different designs you looked at. At any rate, you probably weren’t thinking much about the cover you would use.
Generally, the cover that comes home with your brand-new purchase will be a 4 section rigid foam filled cover that will split in the center and go off both ends.
No big deal.
Up until it starts to get heavy.
Which it constantly does.
Every rigid foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a design flaw. Built in obsolescence because as quickly as it is placed in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper won’t make any distinction. In fact you could have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The particles of steam are very little as they increase from the water surface area. They make their method into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes trapped in the cover.
It occurs gradually and on a Swim Spa Cover which is made from individual areas, at differing speeds. So ultimately you’ll discover a couple of of the areas are really getting heavy. The bar lifters on the ends of the swim spa aren’t much help due to the fact that you still need to raise that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com created a different design for their Lightweight Swim Spa Covers
Instead of using numerous foam panels to develop Lightweight Swim Spa Covers that will eventually wind up in some landfill, they created one that utilizes air chambers that do not suck up wetness.
In fact SpaCap.com Lightweight Swim Spa Covers are easy to use, insulate much better, will not blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine fabric, these covers will not fade, or fall apart at the joints either. So if you own a swim spa, and you mean to keep using it everyday, SpaCap.com has the Swim Spa Cover for it.
If you’re not prepared to purchase today, bookmark this website so you can find it once again when you’re ready!

Leave a Reply

Your email address will not be published. Required fields are marked *